Inside the appliance
Washer drain hose. In plain English.
The drain hose is the part Samsung's drain guide checks first for the no-drain and overflow codes. It should sit 6 to 8 inches into the standpipe or sink, be secured, and not be kinked. If the code stays after those checks, book a technician.

Where it fits.
Washer drain hose in the appliance
Samsung's guide describes the hose end that goes into a standpipe or sink. A holder and screw sit on the back of the washer.
The picture shows a typical example of this component. It does not tell you which replacement fits your model.
What shifts once this system needs attention.
Washer drain hose problems can arrive with weaker performance or a code that keeps coming back. A component is tested before anyone decides it is to blame.

Samsung washer leaking
Samsung says most washer leaks come from conditions you can correct: a damaged hose or o-ring, debris under the door gasket, a drain hose set too deep or too shallow, a dirty pump filter, too much detergent, or a washer that rests off level. Water dripping from the door after you open it is normal. A leak with the door closed is not.

Samsung washer not spinning
No spin at all comes from either a drain problem or a motor problem. Samsung says the washer tries to drain before it spins, so a clogged pump filter or a badly set drain hose can stop the spin before it starts. After clearing the drain side, Samsung suggests Calibration mode. If the tub still does not turn, the washer needs service.

Samsung washer won't start or won't unlock
Two Samsung articles cover this. If the door stays locked or the cycle will not begin, Child Lock, an unfinished cycle, or water still in the tub can be holding the door, and front loaders have an emergency drain hose beside the pump filter. If the washer has no power at all, Samsung lists the cord, a 120V grounded outlet, the breaker and surge protectors.
Owner care, within the model instructions.
Switch the appliance off and unplug it before any check of your own. Look out for pooled water and jagged debris. Never touch a wet plug or an electrical area, take off a service panel or go past what your model's owner instructions allow.
- 1
Measure the insertion
Samsung says the hose should not go in less than 6 or more than 8 inches, and should be secured so it cannot slip down farther.
- 2
Look for kinks and seals
The guide asks that the hose is not kinked, bent or damaged, and that it does not make an airtight connection.
- 3
Check the height and kit
The same list caps the hose at 96 inches (35 inches for wash basins) and says not to use a drain hose extension kit.
Cleaning or replacement?
Leave internal testing to a technician.
The washer still will not drain at the start of the test cycle after the hose checks.
The holder or the screw at the back of the washer is missing.
Arrange a diagnosticSources and model boundaries.
These sources stand behind the Washer drain hose advice. Choose the manual that fits your model.
- Samsung washing machine will not drain
- Samsung washing machine information and error codes
Follow the user manual for your exact model. See how we research these pages.
What does Samsung say about the drain hose screw?
Do not remove the screw on the back that holds the hose against the washer. If it is gone, refit the screw and holder; if the holder is missing, service is needed.
Is a hose problem a common cause?
Samsung calls incorrect drain hose installation the most common reason for drain issues, and says service is rarely required.
Which codes name this part?
The no-drain group (nd, 5E, 5C), the overflow group (OE, OC), the leakage group and the not-filling group.
When do I book?
When the washer will not drain at the start of a test cycle after the hose checks. Bring the display code and your model.
Samsung codes, symptoms, parts, house calls
From the message to what comes next.
nd
nd is Samsung's no-drain error on a washer: water is not draining at the right speed, or at all. Samsung points to its drain guide: level washer, drain hose 6 to 8 inches into the pipe and not kinked, pump filter on front loaders.
Samsung washer leaking
Samsung says most washer leaks come from conditions you can correct: a damaged hose or o-ring, debris under the door gasket, a drain hose set too deep or too shallow, a dirty pump filter, too much detergent, or a washer that rests off level. Water dripping from the door after you open it is normal. A leak with the door closed is not.
Washer repair
Book a diagnostic for your exact model, carried out beside the appliance.
Find your metro
Office details, and the access notes to send us.


