4E is Samsung's not-filling error on a washer: water is not entering the tub correctly. Check the hose connections, open both valves fully and check the drain hose depth. Book a technician with us if it persists after a one-minute power-off.
4E is Samsung's not-filling error on a washer: water is not entering the tub correctly. Check the hose connections, open both valves fully and check the drain hose depth. Book a technician with us if it persists after a one-minute power-off.
Samsung washing machine information and error codes
What Samsung washer 4E means.
What it means
4E is Samsung's not-filling error on a washer: water is not entering the tub correctly. Check the hose connections, open both valves fully and check the drain hose depth. Book a technician with us if it persists after a one-minute power-off.
What you can safely check
Before you look behind a panel, pull the plug and shut both water taps, and mop up any puddle you find.
When to call a technician
4E still shows after the hoses, valves and one-minute power-off.
Your Samsung checks, remembered on this device
Safe checks, in order.
0 of 4 checks done
Illustration. Follow your model’s instructions.
Before you begin
Read the display
Compare the display with 4E one character at a time: Samsung writes it with the digit 4 and a capital E.
Illustration. Follow your model’s instructions.
Check 2
Check the hose inlets
The hot hose goes on the hot inlet and the cold hose on the cold inlet, with neither bent. An unconnected hot line can trigger the error even on cycles labeled Cold.
Illustration. Follow your model’s instructions.
Check 3
Open the valves fully
Open both water valves all the way and leave them open while the washer runs. Samsung says not to use Flood Safe hoses.
Illustration. Follow your model’s instructions.
Check 4
Check the drain hose
It should go no less than 6 and no more than 8 inches into the drain pipe, and not be kinked. Then unplug the washer or flip its breaker for 1 minute and run a cycle.
Still showing 4E?
Tell us your model and the checks you have already run, then open your request from this spot.
For 4E, Samsung says water is not entering the washer correctly. The list covers hose connections, the water valves, the drain hose and a one-minute power-off.
With 4E showing, connect hot to the hot inlet and cold to the cold inlet, with no bends. Open both valves fully. Check the drain hose is 6 to 8 inches into the pipe. Cut power for one minute and retry.
Safety with 4E: Shut both taps and unplug the washer before you disconnect any hose. Keep a towel under the connections, since some water stays in the hoses.
Samsung washing machine information and error codes
Samsung Electronics America (official US support article, samsung.com/us)
page meta date 2026-06-09 (latest of three page dates: 2024-09-04, 2026-05-05, 2026-06-09); no printed revision / article
Scope: Samsung washers, all models unless the article notes otherwise. Source: Samsung washing machine information and error codes (Samsung US support article TSG10000997), checked November 2026. The entry used for 4E is printed as: "4C, 1 4C, nF, 4E: Not filling error" (TSG10000997, web article).
Samsung says water is not entering the washer correctly. The list covers hose connections, the water valves, the drain hose and a one-minute power-off.
Could debris in the water supply cause this?
Samsung says debris is filtered at the inlets and can build up enough to block water. To check, close the valves, disconnect the hoses, look inside the inlet connections and clean the filters.
Why does a Cold cycle still show a fill error without a hot hose?
Samsung notes the washer can try to use hot water even on cycles labeled Cold, so an unconnected hot line can raise the error.
Does 4E mean the same on a dishwasher?
The same characters also appear on a dishwasher, where Samsung ties it to Water supply error. Check which appliance you are standing in front of.
Do I need a visit for 4E?
Samsung sends you to service when the code continues after the hoses, valves, drain hose and power-off. Book a visit with us at that point.
Which other strings does Samsung print with it?
Samsung's line for Not filling error prints 4 strings in this order: 4C, 1 4C, nF, 4E. 4E is number 4 of them.