Inside the appliance
Washer water supply valves. In plain English.
In its not-filling entry Samsung asks that the water supply valves are completely open, along with the hose checks. A half-open valve can leave a washer short of water. If the code returns with the valves fully open, book a technician.

Where it fits.
Washer water supply valves in the appliance
Samsung's article does not locate the valves.
The picture shows a typical example of this component. It does not tell you which replacement fits your model.
What shifts once this system needs attention.
Washer water supply valves problems can arrive with weaker performance or a code that keeps coming back. A component is tested before anyone decides it is to blame.
Owner care, within the model instructions.
Switch the appliance off and unplug it before any check of your own. Look out for pooled water and jagged debris. Never touch a wet plug or an electrical area, take off a service panel or go past what your model's owner instructions allow.
- 1
Open both valves
Samsung's not-filling entry says the water supply valves must be completely open. Turn each one fully before you try again.
- 2
Recheck the hoses
The same entry asks for hot on the hot inlet, cold on the cold inlet, and no kinks. Check these while you are at the valves.
- 3
Power off for a minute
Samsung adds a one-minute power-off for 4C, 1 4C, nF and 4E before the cycle is run again.
Cleaning or replacement?
Leave internal testing to a technician.
4C, 1 4C, nF or 4E returns with the valves fully open and the hoses straight.
A valve will not turn or drips at its stem.
Arrange a diagnosticSources and model boundaries.
These sources stand behind the Washer water supply valves advice. Choose the manual that fits your model.
- Samsung washing machine information and error codes
Follow the user manual for your exact model. See how we research these pages.
Which Samsung codes mention the valves?
4C, 1 4C, nF and 4E, which Samsung groups as the not-filling error.
Does Samsung say where the valves are?
No. It says only that the water supply valves must be completely open.
What else does that entry ask?
Hot and cold hoses on the matching inlets, no kinks, a drain hose inserted 6 to 8 inches, and a one-minute power-off.
What if a valve seems stuck?
Do not force it. Book a technician with us and say which valve and which code.
Samsung codes, symptoms, parts, house calls
From the message to what comes next.
Samsung washer 4C error code
4C is Samsung's not-filling error on a washer: water is not entering the tub correctly. Check the hose connections, open both valves fully and check the drain hose depth. Book a technician with us if it persists after a one-minute power-off.
Samsung washer leaking
Samsung says most washer leaks come from conditions you can correct: a damaged hose or o-ring, debris under the door gasket, a drain hose set too deep or too shallow, a dirty pump filter, too much detergent, or a washer that rests off level. Water dripping from the door after you open it is normal. A leak with the door closed is not.
Washer repair
Book a diagnostic for your exact model, carried out beside the appliance.
Find your metro
Office details, and the access notes to send us.


