Before work starts
The cost of the repair is explained to you on site once the technician has diagnosed the appliance, before any part is ordered or fitted.
Independent appliance repair
Book a visit if your Samsung range, whether freestanding or slide-in, shows a C- code, test mode or a door message. Samsung's range articles are titled "range or wall oven", so we split the two: ranges here, built-in wall ovens on their own page.


For burners that will not light, the Samsung gas range manual lists the plug and fuse or breaker, the gas supply, the control knob not pressed in to the Lite position, burner caps off or the base misaligned, and dirty electrodes. Check those. If you smell gas, turn the knob off, clear the room and call your gas supplier.

The usual reasons a Samsung range oven stays off are a plug not fully in, a fuse that has gone or a breaker that has switched off, wrong settings, or a power cut. On gas models the oven door lock or Sabbath mode can also stop it. Work through those; if the oven stays off, book a technician.
C-d1 on a Samsung range means the door lock is misaligned, per the NE63A6711 manual. Press OFF/CLEAR and restart; if it persists, disconnect power to the range for at least 30 seconds.
C-30 on a Samsung range, per the NE63A6711 manual, means the main PCB sensor is open, or shorted, while the oven operates. Restart; if it persists, disconnect power for at least 30 seconds, then call for service.
C-31 on a Samsung range, per the NE63A6711 manual, occurs when the PCB temperature rises abnormally high. The listed solution is to call for service.
C-d0 on a Samsung range, per the NE63A6711 manual, means there is a short in the control key. Press OFF/CLEAR and restart the oven; if it persists, disconnect power to the range for at least 30 seconds.
C-F0 on a Samsung range is a communication error between components in the range electronics. Induction models NSI6D*9100, NSI6D*9300 and NSI6D*9500 have a SmartThings update (firmware DE92-04769A_24052400 or later) that fixes it without service.
tESt on a Samsung range means it is in Demo mode: the oven and cooktop will not heat, though gas cooktops still ignite. Turn Demo mode off by the steps in your model's user manual.
door on a Samsung range means the oven door is not closed. If it shows with the door shut, check the plunger switch: a round black plastic cap whose pin sticks out about 3/4 inch with the door open.
C-24 on a Samsung range means the oven temperature is rising faster than normal, generally because the vent at the back of the cooktop is blocked. Remove anything covering the vent.
Nothing is named as a part until we have tested the range in place. You see the price and say yes before an order goes in.

C-d1 on a Samsung electric range is printed as: the door lock is misaligned. The manual says to press OFF/CLEAR and restart, then remove all power for half a minute or more if it persists. If that does not solve it, book a technician.

C-30 on Samsung's NE63*671*S* electric range is printed as: the main PCB sensor is open, or shorted, while the oven is operating. The manual says to press OFF/CLEAR and restart, take all power off for half a minute or more, then call for service.
Booking to repair, step by step.
A photo of the display helps.

Choose the appliance and type the code. A quick photo of the display is the best detail you can give.

The technician checks power, sensors and the control board, then quotes the repair before starting.

The part is fitted, the appliance is tested, and the technician shows you it working.
Samsung prints C-d1, C-30, C-31 and others with a hyphen. Compare character by character.
The NE63*671*S* manual's first step for its codes is OFF/CLEAR and a restart.
Where the manual says so, remove all power for half a minute or more.
If the door shows as not closed, Samsung points to the plunger switch and to whether the door closes all the way.
A C- code keeps coming back after OFF/CLEAR and a half-minute without power.
C-31 shows.
The door code stays with the door closed.
Arrange a diagnosticThe cost of the repair is explained to you on site once the technician has diagnosed the appliance, before any part is ordered or fitted.
Repairs that Samsung’s warranty covers are Samsung’s to do. The repairs we make come with our own warranty on the work.
Samsung's articles cover both. On a range the oven sits under the cooktop; a wall oven is a separate unit set into cabinetry, with its page of its own.
Yes. The cooktop and oven share one unit on a range, so we look at both.
Samsung's test mode, where the oven and cooktop will not heat. We read it from the display before anything else.
The display code, your model number, and the fuel the range uses.
Samsung codes, symptoms, parts, house calls
C-d1 on a Samsung range means the door lock is misaligned, per the NE63A6711 manual. Press OFF/CLEAR and restart; if it persists, disconnect power to the range for at least 30 seconds.
For burners that will not light, the Samsung gas range manual lists the plug and fuse or breaker, the gas supply, the control knob not pressed in to the Lite position, burner caps off or the base misaligned, and dirty electrodes. Check those. If you smell gas, turn the knob off, clear the room and call your gas supplier.
C-d1 on a Samsung electric range is printed as: the door lock is misaligned. The manual says to press OFF/CLEAR and restart, then remove all power for half a minute or more if it persists. If that does not solve it, book a technician.
Book a diagnostic for your exact model, carried out beside the appliance.
Office details, and the access notes to send us.