Inside the appliance
Range main PCB sensor. In plain English.
C-30 on Samsung's NE63*671*S* electric range is printed as: the main PCB sensor is open, or shorted, while the oven is operating. The manual says to press OFF/CLEAR and restart, take all power off for half a minute or more, then call for service.

Where it fits.
Range main PCB sensor in the appliance
The manual does not describe its position beyond naming the main PCB.
The picture shows a typical example of this component. It does not tell you which replacement fits your model.
What shifts once this system needs attention.
Range main PCB sensor problems can arrive with weaker performance or a code that keeps coming back. A component is tested before anyone decides it is to blame.

Samsung gas range burners will not light
For burners that will not light, the Samsung gas range manual lists the plug and fuse or breaker, the gas supply, the control knob not pressed in to the Lite position, burner caps off or the base misaligned, and dirty electrodes. Check those. If you smell gas, turn the knob off, clear the room and call your gas supplier.

Samsung range oven will not turn on
The usual reasons a Samsung range oven stays off are a plug not fully in, a fuse that has gone or a breaker that has switched off, wrong settings, or a power cut. On gas models the oven door lock or Sabbath mode can also stop it. Work through those; if the oven stays off, book a technician.
Owner care, within the model instructions.
Switch the appliance off and unplug it before any check of your own. Look out for pooled water and jagged debris. Never touch a wet plug or an electrical area, take off a service panel or go past what your model's owner instructions allow.
- 1
Press OFF/CLEAR
Samsung's range manual says to press OFF/CLEAR and restart.
- 2
Cut the power
If C-30 persists, take all power off the range for half a minute or more.
- 3
Do not confuse with C-31
C-31 is a different entry: the PCB temperature rises abnormally high, and the manual's only line is to call for service.
Cleaning or replacement?
Leave internal testing to a technician.
C-30 comes back after the restart and a half-minute without power.
C-31 shows at any time.
Arrange a diagnosticSources and model boundaries.
These sources stand behind the Range main PCB sensor advice. Choose the manual that fits your model.
- Electric Range User manual NE63*671*S*
Follow the user manual for your exact model. See how we research these pages.
What does C-30 mean on a range?
The range manual prints it as the main PCB sensor being open or shorted while the oven is operating.
Do wall ovens word it the same?
They print PCB sensor open or short. Each manual is scoped to its own model.
Is C-31 related?
It is the next entry: the PCB temperature rises abnormally high.
When do I book?
When C-30 returns after the restart, or at once for C-31.
Samsung codes, symptoms, parts, house calls
From the message to what comes next.
Samsung range C-30 error code
C-30 on a Samsung range, per the NE63A6711 manual, means the main PCB sensor is open, or shorted, while the oven operates. Restart; if it persists, disconnect power for at least 30 seconds, then call for service.
Samsung gas range burners will not light
For burners that will not light, the Samsung gas range manual lists the plug and fuse or breaker, the gas supply, the control knob not pressed in to the Lite position, burner caps off or the base misaligned, and dirty electrodes. Check those. If you smell gas, turn the knob off, clear the room and call your gas supplier.
Range repair
Book a diagnostic for your exact model, carried out beside the appliance.
Find your metro
Office details, and the access notes to send us.

