On this page
- The only detergent requirement is HE; regular, organic and natural products can damage the washer. 1
- Going above the MAX line can stain clothes and damage the washer, including leaks. 1
- The suds pause is automatic and the cycle resumes itself. 2
- Clear leftover suds with empty cycles and no additives. 2
What does the SUd code mean on a Samsung washer?#
It means the washer detected an over-sudsing condition. It stops for a short time so the suds can fade, then continues the cycle by itself, though the code may flash once more at the end as a reminder. 2
The strings Samsung groups here are SUd, 5UD, Sd, 5d, SUdS and 5Ud5. 2 Our page for the family is SUd, with the other spellings listed under it. Samsung is blunt about the cause: this code does not indicate that service is needed and comes from incorrect use of detergent. 2
A near neighbor on the same list is SDC or 5DC, the detergent drawer error. It has nothing to do with foam: the drawer is not completely closed, and Samsung notes it clicks when it is shut properly. 2 If you see that string right after refilling the drawer, press the drawer home until it clicks, then start the cycle again and watch whether the string comes back.
Which detergent does a Samsung washer need?#
HE (High Efficiency) detergent is the single requirement. Samsung says not to use regular, organic or natural detergent, or HE detergents that contain natural ingredients such as vinegar or baking soda, because they can damage the washer. 1
Powder and liquid clean about equally well, the article says; powder can be harder to dissolve in cold water, and liquid can pretreat stains. Whichever you choose, the point is not to use too much. 1 Samsung's code article ties non-HE detergent to the same suds symptom: suds in an empty cycle mean too much detergent or a non-HE product was used. 2
How much detergent should go in?#
Use the least amount that cleans the load, and stay under the MAX line in the drawer. Samsung says exceeding it can stain or damage clothes and also harm the appliance, including causing leaks. 1
Measuring helps: many bottles carry guidance and a cap that doubles as a cup, but a measuring cup or spoon is recommended for accuracy. If the maker's amount for a load is above the MAX line, reduce the load or pick a more concentrated product. HE detergent is very concentrated, and if you are unhappy with results, Samsung says to try a different detergent instead of adding more. 1
Where does the detergent go?#
It depends on the washer type. Front and top loaders have a drawer where liquid goes in the liquid cup and powder goes directly in the compartment with the cup removed. Pods go into the drum before the clothes. 1
A Flex Wash has two places. The upper washer uses the Aqua Pebble, filled up to the MAX line and placed in the center of the tub under the laundry, and pods must not be used there. The lower washer has a compartment, where powder is added directly after removing the container. 1 HE pods and sheets are fine: toss them in the tub, follow the product's directions, and note that small loads may only need half a sheet. 1
Washers with an auto dispenser show a message when the detergent or softener compartment is empty. It clears on the next cycle after you refill, the detergent message during the wash and the softener message during the rinse. 2
How do I clear suds that are already in the machine?#
Run an empty cycle with no detergent, fabric softener or other additives and watch for suds. If they appear, repeat until none do, then check whether the code comes back. 2
Samsung gives this procedure in the entry for water level and leakage codes, where the question is whether a moisture sensor is reacting to suds. 2 If suds do not appear in an empty cycle and the code continues, the entry says the washer needs service. 2 Our LE page lists that family of strings.
- 1
- 2
- 3
- 4
What is the difference between a suds pause and a leak?#
A suds pause is a controlled stop followed by an automatic restart, and the code comes from detergent use. A leak or level code, such as LE, means the washer sensed moisture where it should not be, which can be real water or a sensor issue. 2
Samsung's advice for that second group is broader: look for a leak, however small, check that the hoses behind the washer are not kinked, and run the empty cycle to see whether suds are the trigger. 2 Water pooling around or beneath the washer is a leak, not a suds pause. In that case, close the supply valves and arrange a visit rather than starting further cycles.
Will using less leave the laundry dirtier?#
Samsung's tips point to changing how you wash, not adding more soap. Sorting into whites, colors and bedding, reading care tags, and pretreating stains with a little color-safe liquid detergent all help each load come cleaner. 1
Many models also offer presoak and prewash options, and some top loaders have an Activewash sink or jet for pre-rinsing. 1 Loading matters as well: do not put in more than the washer can handle, and let the detergent amount follow the load, so a load much smaller than usual gets a smaller dose. 1 A heavily soiled load is therefore a case for a pretreat or a presoak, not for a double dose.
If you have been overdosing for a while, expect residue. Samsung says too much detergent builds up inside the washer and hurts its performance, which is why the empty cycles above are worth the time before you trust the machine with a full load again. 12
Which habits keep the code from coming back?#
Five habits cover most of it, and every one comes straight from Samsung's detergent guidance. 1
- Use HE detergent, and HE pods or sheets, only.
- Keep to the measuring cup or spoon, not an eyeball pour.
- Never go over the MAX line, even when the bottle suggests a bigger dose for a large load; shrink the load instead.
- If a detergent underperforms, swap the product rather than adding more.
- Put powder, liquid and pods in the place the washer type calls for.
Check the cap too, since it is the part most people use as a scoop. Samsung notes that the cap of many bottles works as a measuring cup, but that the amount printed for a load can exceed what your drawer's MAX line allows. 1 In that case the drawer wins.
Which situations call for a visit?#
Book when suds are gone after the empty cycles and the code still returns, when detergent or water escapes the machine, or if it fails to resume after the pause. Samsung's answer to a persistent code with no suds is service. 2
Book a technician , giving the exact string on the display, the detergent and amount you use, and the number of empty cycles you ran. We have no link to Samsung, so any washer still inside its warranty term is repaired through Samsung. Our washer repair page explains a visit, and calibration mode is the guide to read if the washer fills oddly after a move.
Sources#
- How to use detergent in your Samsung washing machineSamsung Electronics America (official US support article, samsung.com/us) · Page meta date 2026-04-03; fetched 12.11.2026 · Sections Use the right kind of detergent; Use the right amount of detergent; Add detergent to your washing machine; Add detergent pods or sheets
- Samsung washing machine information and error codesSamsung Electronics America (official US support article, samsung.com/us) · Page meta date 2026-06-09; fetched 12.11.2026 · Entries SUd, 5UD, Sd, 5d, SUdS, 5Ud5: Excessive suds error; 1E, LE, 1C, LC: Water level or leakage error; Refill detergent or softener




