Inside the appliance
Dryer heater. In plain English.
Samsung's dryer heating errors are HC, hE, HC4 and 1 HC, and they mean the dryer is getting too hot. The usual cause is a blocked lint filter or exhaust duct holding heat in. Clean both. On an electric dryer, low supply voltage is another cause Samsung names.

Where it fits.
Dryer heater in the appliance
Samsung's article does not give the heater's position.
The picture shows a typical example of this component. It does not tell you which replacement fits your model.
What shifts once this system needs attention.
Dryer heater problems can arrive with weaker performance or a code that keeps coming back. A component is tested before anyone decides it is to blame.
Owner care, within the model instructions.
Switch the appliance off and unplug it before any check of your own. Look out for pooled water and jagged debris. Never touch a wet plug or an electrical area, take off a service panel or go past what your model's owner instructions allow.
- 1
Wipe the lint screen
Remove lint from the screen and from the housing around it.
- 2
Clear the duct run
Clear the exhaust duct that leads out of the house. Unplug the dryer before you move it.
- 3
Ask about voltage
On an electric dryer, Samsung says the heater can run not hot enough when voltage is low. An electrician can check what the outlet supplies.
- 4
Run it again
Once cleaned, run a cycle to learn if the heating code returns.
Cleaning or replacement?
Leave internal testing to a technician.
The heating code continues once the screen and duct are clear.
An electrician finds normal voltage and the code still returns.
Arrange a diagnosticSources and model boundaries.
These sources stand behind the Dryer heater advice. Choose the manual that fits your model.
- Samsung dryer displays an error code
Follow the user manual for your exact model. See how we research these pages.
What do HC, hE, HC4 and 1 HC mean?
Samsung lists them as heating errors: the dryer is getting too hot. They are one group on its dryer error page.
What is the most common cause?
A blocked lint filter or exhaust duct. Samsung says cleaning the lint screen, the vent or both corrects the error.
Can low voltage cause it?
Samsung says in some cases the heater is not hot enough, caused by low voltage on electric dryers. It has an electrician check the voltage supplied.
Should I open the dryer to look at the heater?
Samsung gives no home steps inside the cabinet. Wipe the lint screen and the duct, then send us a booking request if the code remains.
Samsung codes, symptoms, parts, house calls
From the message to what comes next.
Samsung dryer HC error code
HC is a heating error on a Samsung dryer: it is getting too hot. The most common cause is a clogged lint screen or vent. Clean both. On an electric dryer, low supply voltage can also cause it. Book a technician with us if it continues.
Samsung dryer won't start or spin
Samsung says a dryer that powers on but will not spin usually needs service. Before that, look for an error code, turn off Child Lock (its icon is lit), then run the Time Dry test: if the timer counts down and the drum stays motionless, the dryer needs a technician. If the buttons will not respond at all, Child Lock is the usual reason.
Dryer repair
Book a diagnostic for your exact model, carried out beside the appliance.
Find your metro
Office details, and the access notes to send us.


