Inside the appliance
Cooktop cooling fan. In plain English.
An internal fan cools the electronics of a Samsung induction cooktop. It starts after you use an element and keeps going until the electronics are cool, so noise after switch-off is normal. A2 means the DC motor locked up, from a board or wiring problem or an obstruction at the blade.

Where it fits.
Cooktop cooling fan in the appliance
Inside the cooktop; Samsung does not describe the fan position.
The picture shows a typical example of this component. It does not tell you which replacement fits your model.
What shifts once this system needs attention.
Cooktop cooling fan problems can arrive with weaker performance or a code that keeps coming back. A component is tested before anyone decides it is to blame.

Samsung electric cooktop slow to boil or cycling on and off
A Samsung electric cooktop unit that switches on and off is behaving normally, even on high, and does so more with an undersized pan or one with a curved base. A unit that will not hold a rolling boil usually points to the pan or low voltage. Use flat pans that match the unit and cover them with a lid.

Samsung electric cooktop surface unit will not turn on
When a surface unit on a Samsung electric cooktop stays off, the manual blames a blown fuse, a tripped breaker, or a control meant for a different unit. Reset the breaker, then check that you are using the correct control for the unit you want.
Owner care, within the model instructions.
Switch the appliance off and unplug it before any check of your own. Look out for pooled water and jagged debris. Never touch a wet plug or an electrical area, take off a service panel or go past what your model's owner instructions allow.
- 1
Expect the fan
Samsung says the internal fan may switch on for cooling after elements have been used. It gives two run times, 10 minutes or 20, set by the internal sensor temperature.
- 2
Treat the noise as normal
Hissing or buzzing from the fan, even after you switch off, is expected; it stops by itself soon after.
- 3
Mind the cabinet above
Samsung asks that items in a cabinet over the cooking surface be rarely used and safely stored.
- 4
Read A2
If A2 shows, write it down. Samsung prints its meaning, DC motor locking, but no owner steps.
Cleaning or replacement?
Leave internal testing to a technician.
A2 shows on the display.
The fan runs without end, or the cooktop shuts down from overheating.
Arrange a diagnosticSources and model boundaries.
These sources stand behind the Cooktop cooling fan advice. Choose the manual that fits your model.
- Electric Cooktop User manual NZ30K7880U*, DG68-00823A-09
Follow the user manual for your exact model. See how we research these pages.
What keeps the fan going?
Samsung says it continues until the cooktop's electronics are cool and then stops by itself.
For how long?
It starts after you use an element: 10 minutes or 20, set by the internal sensor, says Samsung.
What is A2?
Samsung's wording is DC Motor Locking Information: the motor is unable to turn, due to a defect in the board or wiring or a blockage at the blade.
Does fan noise mean a defect?
Not alone. Samsung lists hissing or buzzing from the fan among sounds that do not point to a defect.
Samsung codes, symptoms, parts, house calls
From the message to what comes next.
A2
A2 on a Samsung induction cooktop is DC motor locking: the DC motor cannot operate because of defects in the PCB or wiring, or a blockage of the motor blade.
Samsung electric cooktop slow to boil or cycling on and off
A Samsung electric cooktop unit that switches on and off is behaving normally, even on high, and does so more with an undersized pan or one with a curved base. A unit that will not hold a rolling boil usually points to the pan or low voltage. Use flat pans that match the unit and cover them with a lid.
Cooktop repair
Book a diagnostic for your exact model, carried out beside the appliance.
Find your metro
Office details, and the access notes to send us.

