What it means
bAd LinE on a Samsung range means the power connection is not plugged in properly. Reconnect it and confirm it is correct against the installation manual or with a professional installer.
Samsung range bAd LinE / Power supply
bAd LinE on a Samsung range means the power connection is not plugged in properly. Reconnect it and confirm it is correct against the installation manual or with a professional installer.
Also shown as bAd LinE
bAd LinE on a Samsung range means the power connection is not plugged in properly. Reconnect it and confirm it is correct against the installation manual or with a professional installer.
Turn the breaker off before you go behind a panel; wiring and gas lines are work for a technician.
The connection looks right and bAd LinE still shows.
Your Samsung checks, remembered on this device

Note exactly what the display shows, including capitals and spaces, before you act on it.

Before you touch the connection.

Compare it with the installation manual.

Switch the breaker on and retest.
Tell us your model and the checks you have already run, then open your request from this spot.
Book a visitThis is a sketch, because the inside of a Samsung changes from model to model. Tap an outlined part for its photo and the matching check.
For bAd LinE, Samsung says the power connection is not plugged in properly and tells you to reconnect it and make sure it is correct.
Read the supporting manualWith bAd LinE showing, switch off at the breaker, check the power connection against the installation manual, and reconnect it.
Read the supporting manualSafety with bAd LinE: A range runs on a high-current circuit. Switch off at the breaker before checking, and leave rewiring to a qualified installer.
Read the supporting manualOn a small display the b in bAd LinE can be taken for 6. Samsung's range list has no row spelled that way, so bAd LinE is the reading to look up.
Read the supporting manualManufacturer document
Samsung Electronics America (official US support article, samsung.com/us)
page meta date 2026-05-05; no printed revision / article
Scope: Samsung ranges, all models unless the article notes otherwise. Source: Samsung range or wall oven error codes (Samsung US support article TSG10003529), checked November 2026.
Samsung says the power connection is not plugged in properly and tells you to reconnect it and make sure it is correct.
Samsung names the installation manual or a professional installer.
On a small display the b in bAd LinE can be taken for 6. Samsung's range list has no row spelled that way, so bAd LinE is the reading to look up.
Book a visit with us if the connection is right and the message stays, or if the plug or cord looks damaged.
Samsung codes, symptoms, parts, house calls
Cooktop in use on a Samsung range means Self Clean cannot start because a cooktop burner or element is still on. Turn every burner or element off, then start Self Clean again.
For burners that will not light, the Samsung gas range manual lists the plug and fuse or breaker, the gas supply, the control knob not pressed in to the Lite position, burner caps off or the base misaligned, and dirty electrodes. Check those. If you smell gas, turn the knob off, clear the room and call your gas supplier.
Book a diagnostic for your exact model, carried out beside the appliance.
Office details, and the access notes to send us.