What it means
1 SF appears on Samsung's list of other washer errors as a System Error. Samsung gives the name only, with no specific steps. Power the washer off for 2 to 3 minutes, power it on and restart. Book a technician with us if it continues.
Samsung washer 1 SF / Control board
1 SF appears on Samsung's list of other washer errors as a System Error. Samsung gives the name only, with no specific steps. Power the washer off for 2 to 3 minutes, power it on and restart. Book a technician with us if it continues.
Also shown as 1 SF
1 SF appears on Samsung's list of other washer errors as a System Error. Samsung gives the name only, with no specific steps. Power the washer off for 2 to 3 minutes, power it on and restart. Book a technician with us if it continues.
Before you look behind a panel, pull the plug and shut both water taps, and mop up any puddle you find.
1 SF returns after the power-off and restart.
Your Samsung checks, remembered on this device

Compare the display with 1 SF one character at a time: Samsung writes it with the digit 1, a space, a capital S and a capital F.

Turn the washer off and leave it for 2 to 3 minutes.

Turn it back on and restart the cycle.

Write down the exact characters; some strings start with a digit and some with a letter.
Tell us your model and the checks you have already run, then open your request from this spot.
Book a visit
This is a sketch, because the inside of a Samsung changes from model to model. Tap an outlined part for its photo and the matching check.
For 1 SF, Samsung lists it in "All other errors" as a System Error, and gives no specific steps for it, only the basic power-cycle steps.
Read the supporting manualWith 1 SF showing, power the washer off for 2 to 3 minutes, power it back on and restart the cycle. If the code comes back, note what the washer was doing when it appeared.
Read the supporting manualTreat a repeating system error as a service matter. Unplug the washer before you open any panel, and do not bypass any part.
Read the supporting manual1 5C (No drain error) differs from 1 SF by a single character, and Samsung lists it as a separate entry for this washer. On a small display the 1 in 1 SF can be taken for I or l. Samsung's washer list has no row spelled that way, so 1 SF is the reading to look up.
Read the supporting manualManufacturer document
Samsung Electronics America (official US support article, samsung.com/us)
page meta date 2026-06-09 (latest of three page dates: 2024-09-04, 2026-05-05, 2026-06-09); no printed revision / article
Scope: Samsung washers, all models unless the article notes otherwise. Source: Samsung washing machine information and error codes (Samsung US support article TSG10000997), checked November 2026. The entry used for 1 SF is printed as: "IE, SF, 5F, SF1, SF2, SF3, 5F1, 5F2, 5F3, 1 SF - System Error" (TSG10000997, web article).
Samsung lists it in "All other errors" as a System Error, and gives no specific steps for it, only the basic power-cycle steps.
No. It is in the "All other errors" part of the list, where the basic power-off, power-on and restart steps apply.
1 SF is SF with a leading 1. Samsung lists the two together under System Error and does not say what the 1 changes, so read them as one meaning.
Samsung says to request service if the error continues after the basic steps. Book a visit with us at that point.
Samsung's line for System Error prints 10 strings, and 1 SF is number 10, right after 5F3.
Samsung codes, symptoms, parts, house calls
IE appears on Samsung's list of other washer errors as a System Error. Samsung gives the name only, with no specific steps. Power the washer off for 2 to 3 minutes, power it on and restart. Book a technician with us if it continues.
Samsung says most washer leaks come from conditions you can correct: a damaged hose or o-ring, debris under the door gasket, a drain hose set too deep or too shallow, a dirty pump filter, too much detergent, or a washer that rests off level. Water dripping from the door after you open it is normal. A leak with the door closed is not.
Book a diagnostic for your exact model, carried out beside the appliance.
Office details, and the access notes to send us.