What it means
IE appears on Samsung's list of other washer errors as a System Error. Samsung gives the name only, with no specific steps. Power the washer off for 2 to 3 minutes, power it on and restart. Book a technician with us if it continues.
Samsung washer IE / Control board
IE appears on Samsung's list of other washer errors as a System Error. Samsung gives the name only, with no specific steps. Power the washer off for 2 to 3 minutes, power it on and restart. Book a technician with us if it continues.
Also shown as IE
IE appears on Samsung's list of other washer errors as a System Error. Samsung gives the name only, with no specific steps. Power the washer off for 2 to 3 minutes, power it on and restart. Book a technician with us if it continues.
Before you look behind a panel, pull the plug and shut both water taps, and mop up any puddle you find.
IE returns after the power-off and restart.
Your Samsung checks, remembered on this device

Compare the display with IE one character at a time: Samsung writes it with a capital I and a capital E.

Turn the washer off and leave it for 2 to 3 minutes.

Turn it back on and restart the cycle.

Write down the exact characters; some strings start with a digit and some with a letter.
Tell us your model and the checks you have already run, then open your request from this spot.
Book a visit
This is a sketch, because the inside of a Samsung changes from model to model. Tap an outlined part for its photo and the matching check.
For IE, Samsung lists it in "All other errors" as a System Error, and gives no specific steps for it, only the basic power-cycle steps.
Read the supporting manualWith IE showing, power the washer off for 2 to 3 minutes, power it back on and restart the cycle. If the code comes back, note what the washer was doing when it appeared.
Read the supporting manualSafety with IE: Treat a repeating system error as a service matter. Unplug the washer before you open any panel, and do not bypass any part.
Read the supporting manual1E differs from IE only by a look-alike character, I against 1, yet Samsung lists it for this washer as Water level or leakage error. Check the screen closely.
Read the supporting manualManufacturer document
Samsung Electronics America (official US support article, samsung.com/us)
page meta date 2026-06-09 (latest of three page dates: 2024-09-04, 2026-05-05, 2026-06-09); no printed revision / article
Scope: Samsung washers, all models unless the article notes otherwise. Source: Samsung washing machine information and error codes (Samsung US support article TSG10000997), checked November 2026. The entry used for IE is printed as: "IE, SF, 5F, SF1, SF2, SF3, 5F1, 5F2, 5F3, 1 SF - System Error" (TSG10000997, web article).
Samsung lists it in "All other errors" as a System Error, and gives no specific steps for it, only the basic power-cycle steps.
No. It is in the "All other errors" part of the list, where the basic power-off, power-on and restart steps apply.
1E differs from IE only by a look-alike character, I against 1, yet Samsung lists it for this washer as Water level or leakage error. Check the screen closely.
Samsung says to request service if the error continues after the basic steps. Book a visit with us at that point.
Samsung's line for System Error prints 10 strings, and IE is number 1, right before SF.
Samsung codes, symptoms, parts, house calls
SF appears on Samsung's list of other washer errors as a System Error. Samsung gives the name only, with no specific steps. Power the washer off for 2 to 3 minutes, power it on and restart. Book a technician with us if it continues.
Samsung says most washer leaks come from conditions you can correct: a damaged hose or o-ring, debris under the door gasket, a drain hose set too deep or too shallow, a dirty pump filter, too much detergent, or a washer that rests off level. Water dripping from the door after you open it is normal. A leak with the door closed is not.
Book a diagnostic for your exact model, carried out beside the appliance.
Office details, and the access notes to send us.