What it means
PE is Samsung's half load function error on a dishwasher: the half load function is not performing correctly. Empty it, add detergent and run a half load cycle. Book a technician with us if it persists.
Samsung dishwasher PE / Motor and drive
PE is Samsung's half load function error on a dishwasher: the half load function is not performing correctly. Empty it, add detergent and run a half load cycle. Book a technician with us if it persists.
Also shown as PE
PE is Samsung's half load function error on a dishwasher: the half load function is not performing correctly. Empty it, add detergent and run a half load cycle. Book a technician with us if it persists.
Cut power to the dishwasher at its breaker before you reach into the base or behind a panel, and clear up any standing water first.
PE comes back on the half load cycle.
Your Samsung checks, remembered on this device

Compare the display with PE one character at a time: Samsung writes it with a capital P and a capital E.

Remove the dishes.

Put detergent in the dispenser.

Start the half load cycle and see whether the code returns.
Tell us your model and the checks you have already run, then open your request from this spot.
Book a visit
This is a sketch, because the inside of a Samsung changes from model to model. Tap an outlined part for its photo and the matching check.

Component reference
PC is Samsung's Zone Wash error: the Zone Wash function is not operating correctly.
Read the definitionSamsung says the half load function is not performing correctly.
Read the supporting manualEmpty the dishwasher, add detergent and run a half load cycle.
Read the supporting manualCut power at the breaker before reaching into the base.
Read the supporting manualThe same characters also appear on a washer, where Samsung ties it to Clutch Position Error. Check which appliance you are standing in front of.
Read the supporting manualManufacturer document
Samsung Electronics America (official US support article, samsung.com/us)
page meta date 2026-05-01; no printed revision / article
Scope: Samsung dishwashers, all models unless the article notes otherwise. Source: Samsung dishwasher is displaying an error code (Samsung US support article TSG10004499), checked November 2026. The entry used for PE is printed as: "PE - Half load function error" (TSG10004499, web article).
Samsung says the half load function is not performing correctly.
Samsung does not say. Try a normal cycle to see whether only the half load function is affected.
The same characters also appear on a washer, where Samsung ties it to Clutch Position Error. Check which appliance you are standing in front of.
If the error continues, book a visit with us.
Samsung codes, symptoms, parts, house calls
3C is Samsung's pump operation error on a dishwasher: the pump has failed. Turn the dishwasher off and try the cycle again. Book a technician with us if the error still occurs.
Samsung's article for a dishwasher that does not turn on lists a short set of checks: touch Power with dry hands, wipe a grimy Power button, look for a tripped breaker, and find the wall switch some kitchens have. If it has done this since installation, Samsung says service is not the answer and the installer should check the electrical supply.
PC is Samsung's Zone Wash error: the Zone Wash function is not operating correctly. Samsung's step is to turn the dishwasher off and start the cycle again. If PC returns, book a technician.
Book a diagnostic for your exact model, carried out beside the appliance.
Office details, and the access notes to send us.