What it means
An H or h on a Samsung induction cooktop display shows leftover warmth. The zone is off, yet the glass can still burn, so keep your hands and towels clear. The mark disappears only after the zone has cooled. Nothing is wrong.
Samsung cooktop H / Mode, not a failure
An H or h on a Samsung induction cooktop display shows leftover warmth. The zone is off, yet the glass can still burn, so keep your hands and towels clear. The mark disappears only after the zone has cooled. Nothing is wrong.
Also shown as H
An H or h on a Samsung induction cooktop display shows leftover warmth. The zone is off, yet the glass can still burn, so keep your hands and towels clear. The mark disappears only after the zone has cooled. Nothing is wrong.
The manual warns of a burn risk for as long as the indicator is lit.
The mark stays lit long after the zone has cooled, or shows on a zone that was never switched on.
Your Samsung checks, remembered on this device

The manual warns of a burn risk for as long as the indicator is lit. Keep skin, towels and plastic off that zone.

Samsung says the capital H signals a higher temperature than the lowercase h. Capital means hotter.

Samsung notes that residual heat can thaw food or keep a pot warm. Set the pan on the marked zone and leave it.

The mark fades on its own as the zone cools. Wiping the glass earlier risks burns and baked-on spills.
If the zone has been off for hours and the mark stays, or it shows on a zone that was never used, the sensor needs a technician.
Tell us your model and the checks you have already run, then open your request from this spot.
Book a visitThis is a sketch, because the inside of a Samsung changes from model to model. Tap an outlined part for its photo and the matching check.

Component reference
F0 on a Samsung NZ30K7880U* or NZ30A3060UK induction cooktop reports that communication between the main and sub PCBs failed.
Read the definitionIt stands for “hot”. When a zone or the whole cooktop is switched off, an H or h appears over each zone that is still warm.
Read the supporting manualThe capital letter marks higher temperatures than the lowercase one. Both mean the surface can burn you.
Read the supporting manualOnly after the zone has cooled, even though the zone is already off. Nothing you press will clear it sooner.
Read the supporting manualIf power to the cooktop is interrupted, the symbol goes out and heat information is no longer shown, yet the glass can still burn you.
Read the supporting manualManufacturer document
Samsung Electronics America (official manual PDF, downloadcenter.samsung.com)
DG68-01384A, PDF created 14.01.2025; US contact and warranty on p34 / PDF p18
Read from the NZ30A3060UK manual’s display list and the residual heat indicator section. The NZ30K7880US prints the same indicator.
Not at all. Samsung lists it among the ordinary digits and symbols the display uses.
You can use the leftover heat to warm food or thaw it, as Samsung notes, but expect a hot surface and set the pan down carefully.
The indicator needs power to show. When supply is interrupted the symbol goes out, but the glass may still be hot.
Nothing in the manual says it does. Read it as a warning and take extra care around that zone.
Samsung codes, symptoms, parts, house calls
When L shows on a Samsung induction cooktop, it means the child lock is engaged. Touching the zones does nothing until you unlock. Hold the Lock key for about 3 seconds, wait for the beep, and the cooktop responds again.
A Samsung electric cooktop unit that switches on and off is behaving normally, even on high, and does so more with an undersized pan or one with a curved base. A unit that will not hold a rolling boil usually points to the pan or low voltage. Use flat pans that match the unit and cover them with a lid.
F0 on a Samsung NZ30K7880U* or NZ30A3060UK induction cooktop reports that communication between the main and sub PCBs failed. The manual says to restart with the POWER key and disconnect power for more than 30 seconds if it continues.
Book a diagnostic for your exact model, carried out beside the appliance.
Office details, and the access notes to send us.