What it means
On a Samsung washer, blinking Extra Large, or Extra High, or Large, or High lights are read as: water is not entering the washer correctly. Book a technician with us if the same lights return and the washer stops working normally.
Samsung washer Extra Large, or Extra High, or Large, or High / Blinking lights
On a Samsung washer, blinking Extra Large, or Extra High, or Large, or High lights are read as: water is not entering the washer correctly. Book a technician with us if the same lights return and the washer stops working normally.
Also shown as Extra Large, or Extra High, or Large, or High
On a Samsung washer, blinking Extra Large, or Extra High, or Large, or High lights are read as: water is not entering the washer correctly. Book a technician with us if the same lights return and the washer stops working normally.
Before you look behind a panel, pull the plug and shut both water taps, and mop up any puddle you find.
The same lights blink again and the washer still does not run normally.
Your Samsung checks, remembered on this device

Confirm that exactly Extra Large, or Extra High, or Large, or High blink, not more and not fewer. Blinking can also be part of normal operation, so treat it as a code only if the washer is not working normally.

Hot hose on the hot inlet, cold hose on the cold inlet, neither bent.

Open both water valves completely.

No more than 6 inches into the drain pipe, and not kinked. Then unplug or flip the breaker for 1 minute.
Tell us your model and the checks you have already run, then open your request from this spot.
Book a visit
This is a sketch, because the inside of a Samsung changes from model to model. Tap an outlined part for its photo and the matching check.
Samsung reads blinking Extra Large, or Extra High, or Large, or High lights as: water is not entering the washer correctly.
Read the supporting manualCheck the hose connections, open the valves, check the drain hose and cut power for 1 minute.
Read the supporting manualNo. Samsung says lights may blink as part of regular use, so it is an error only if the washer also is not working normally, for example stopping mid-cycle.
Read the supporting manualNo other pattern in Samsung's washer list differs from Extra Large, or Extra High, or Large, or High by a single light, so nothing close to it carries a different reading.
Read the supporting manualManufacturer document
Samsung Electronics America (official US support article, samsung.com/us)
page meta date 2026-06-09 (latest of three page dates: 2024-09-04, 2026-05-05, 2026-06-09); no printed revision / article
Scope: Samsung washers, all models unless the article notes otherwise. Source: Samsung washing machine information and error codes (Samsung US support article TSG10000997), checked November 2026.
Samsung reads them as: water is not entering the washer correctly.
No. Samsung says it is a code only if the washer is also not working normally, such as stopping mid-cycle.
Check the hose connections, open the valves, check the drain hose and cut power for 1 minute.
Samsung says to request service if the lights return. Book a visit with us at that point.
Extra Large, or Extra High, or Large, or High names 4 lights: ExtraHigh, ExtraLarge, Large, High. Samsung lists it as its own pattern, separate from every other combination of these lights.
No other pattern in Samsung's washer list differs from Extra Large, or Extra High, or Large, or High by a single light, so nothing close to it carries a different reading.
Samsung codes, symptoms, parts, house calls
4C is Samsung's not-filling error on a washer: water is not entering the tub correctly. Check the hose connections, open both valves fully and check the drain hose depth. Book a technician with us if it persists after a one-minute power-off.
Samsung says most washer leaks come from conditions you can correct: a damaged hose or o-ring, debris under the door gasket, a drain hose set too deep or too shallow, a dirty pump filter, too much detergent, or a washer that rests off level. Water dripping from the door after you open it is normal. A leak with the door closed is not.
Book a diagnostic for your exact model, carried out beside the appliance.
Office details, and the access notes to send us.