What it means
C-F2 on a Samsung built-in wall oven occurs when communication between the Main and Touch is interrupted. The manuals print the code with no further steps.
Samsung oven C-F2 / Control board
C-F2 on a Samsung built-in wall oven occurs when communication between the Main and Touch is interrupted. The manuals print the code with no further steps.
Also shown as C-F2
C-F2 on a Samsung built-in wall oven occurs when communication between the Main and Touch is interrupted. The manuals print the code with no further steps.
Turn the breaker off before you go behind a panel; wiring is work for a technician.
C-F2 comes back once the power has been cut and restored.
Your Samsung checks, remembered on this device

Compare the display with C-F2 one character at a time: Samsung writes it with a capital C, a hyphen, a capital F and the digit 2.

Then restart.

At least 30 seconds.
See whether the keys respond.
Tell us your model and the checks you have already run, then open your request from this spot.
Book a visitThis is a sketch, because the inside of a Samsung changes from model to model. Tap an outlined part for its photo and the matching check.
For C-F2, both wall oven manuals say the code occurs if communication between the Main and Touch is interrupted.
Read the supporting manualWith C-F2 showing, press OFF and restart the oven; if it persists, disconnect all power to the oven for at least 30 seconds, as the manuals do for the other board codes.
Read the supporting manualSafety with C-F2: Switch the oven off at its breaker before disconnecting power.
Read the supporting manualC-72 (drain system) differs from C-F2 by a single character, and Samsung lists it as a separate entry for this wall oven. C-A2 (cooling motor) differs from C-F2 by a single character, and Samsung lists it as a separate entry for this wall oven.
Read the supporting manualManufacturer document
Samsung Electronics America (official manual PDF, downloadcenter.samsung.com)
DG68-00856A-03, printed footer 2018-08-29; PDF modified 17.04.2019; carries Warranty (U.S.A) on the same page as the code table (p59) / PDF p58
Manufacturer document
Samsung Electronics America (official manual PDF, downloadcenter.samsung.com)
Samsung user manual PDF created 15.01.2026 (no printed revision code on the cover) / PDF p65
Scope: NV51**700D** built-in electric wall ovens (NV7000C series); NV51K7770D* built-in electric wall ovens. Source: Built-In Electric Wall Oven User manual NV51K7770D*; Built-In Electric Wall Oven User manual NV51**700D**, checked November 2026. The entry used for C-F2 is printed as: "Main and Touch is interrupted." (NV51K7770D_AA_DG68-00856A-03_EN-MES-CFR, page 58).
Both wall oven manuals say the code occurs if communication between the Main and Touch is interrupted.
No separate steps are printed for it.
The same characters also appear on a range, where Samsung ties it to main-to-touch communication. Check which appliance you are standing in front of.
Book a visit with us if the code returns after the power reset.
Samsung codes, symptoms, parts, house calls
C-d0 on a Samsung built-in wall oven means the control key is shorted for 1 minute. Wipe the buttons clean, dry any water on or around them, then switch the oven off and try again.
If food bakes or roasts poorly in a Samsung wall oven, the manual looks first at controls set incorrectly, a rack in the wrong place or not level, and wrong cookware. An oven that runs too hot or cold may need its thermistor adjusted in Settings, Adjust Temp. Low voltage can also slow broiling.
Book a diagnostic for your exact model, carried out beside the appliance.
Office details, and the access notes to send us.