What it means
C-30 on a Samsung built-in wall oven means the PCB sensor is open or shorted while the oven operates. Press OFF, restart, disconnect power for at least 30 seconds if it persists, then call for service.
Samsung oven C-30 / Sensors
C-30 on a Samsung built-in wall oven means the PCB sensor is open or shorted while the oven operates. Press OFF, restart, disconnect power for at least 30 seconds if it persists, then call for service.
Also shown as C-30
C-30 on a Samsung built-in wall oven means the PCB sensor is open or shorted while the oven operates. Press OFF, restart, disconnect power for at least 30 seconds if it persists, then call for service.
Turn the breaker off before you go behind a panel; wiring is work for a technician.
C-30 returns.
Your Samsung checks, remembered on this device

Compare the display with C-30 one character at a time: Samsung writes it with a capital C, a hyphen, the digit 3 and the digit 0.

Then restart.

At least 30 seconds, then reconnect.

If it persists.
Tell us your model and the checks you have already run, then open your request from this spot.
Book a visitThis is a sketch, because the inside of a Samsung changes from model to model. Tap an outlined part for its photo and the matching check.
For C-30, the wall oven manuals say the PCB sensor is open when the oven is operating, and list the matching short. The range manual words the same code as the main PCB sensor.
Read the supporting manualWith C-30 showing, press OFF and restart the oven. If it persists, disconnect all power to the oven for at least 30 seconds, reconnect, and call for service if it does not clear.
Read the supporting manualSafety with C-30: Switch the oven off at its breaker first.
Read the supporting manualC-20 (oven sensor) differs from C-30 by a single character, and Samsung lists it as a separate entry for this wall oven. C-31 (control board temperature high) differs from C-30 by a single character, and Samsung lists it as a separate entry for this wall oven.
Read the supporting manualManufacturer document
Samsung Electronics America (official manual PDF, downloadcenter.samsung.com)
DG68-00856A-03, printed footer 2018-08-29; PDF modified 17.04.2019; carries Warranty (U.S.A) on the same page as the code table (p59) / PDF p59
Manufacturer document
Samsung Electronics America (official manual PDF, downloadcenter.samsung.com)
Samsung user manual PDF created 15.01.2026 (no printed revision code on the cover) / PDF p65
Scope: NV51**700D** built-in electric wall ovens (NV7000C series); NV51K7770D* built-in electric wall ovens. Source: Built-In Electric Wall Oven User manual NV51K7770D*; Built-In Electric Wall Oven User manual NV51**700D**, checked November 2026.
The wall oven manuals say the PCB sensor is open when the oven is operating, and list the matching short. The range manual words the same code as the main PCB sensor.
As the main PCB sensor being open or short while the oven operates.
On a small display the 0 in C-30 can be taken for O or o. Samsung's wall oven list has no row spelled that way, so C-30 is the reading to look up.
Book a visit with us if the power reset does not clear it.
Samsung codes, symptoms, parts, house calls
C-d0 on a Samsung built-in wall oven means the control key is shorted for 1 minute. Wipe the buttons clean, dry any water on or around them, then switch the oven off and try again.
If food bakes or roasts poorly in a Samsung wall oven, the manual looks first at controls set incorrectly, a rack in the wrong place or not level, and wrong cookware. An oven that runs too hot or cold may need its thermistor adjusted in Settings, Adjust Temp. Low voltage can also slow broiling.
Book a diagnostic for your exact model, carried out beside the appliance.
Office details, and the access notes to send us.