What it means
C-20 on a Samsung built-in wall oven means the oven sensor is open or shorted while the oven operates. Press OFF, restart, and if it persists disconnect power to the oven for at least 30 seconds.
Samsung oven C-20 / Sensors
C-20 on a Samsung built-in wall oven means the oven sensor is open or shorted while the oven operates. Press OFF, restart, and if it persists disconnect power to the oven for at least 30 seconds.
Also shown as C-20
C-20 on a Samsung built-in wall oven means the oven sensor is open or shorted while the oven operates. Press OFF, restart, and if it persists disconnect power to the oven for at least 30 seconds.
Turn the breaker off before you go behind a panel; wiring is work for a technician.
C-20 returns after the restart.
Your Samsung checks, remembered on this device

Compare the display with C-20 one character at a time: Samsung writes it with a capital C, a hyphen, the digit 2 and the digit 0.

Then restart the oven.

For at least 30 seconds, then reconnect.

Write down whether it came during preheat or after some time at temperature.
Tell us your model and the checks you have already run, then open your request from this spot.
Book a visitThis is a sketch, because the inside of a Samsung changes from model to model. Tap an outlined part for its photo and the matching check.
For C-20, both wall oven manuals (NV51K7770D and NV51700D) say the oven sensor is open, or short, while the oven is operating.
Read the supporting manualWith C-20 showing, press OFF and restart the oven. Should it continue, cut all power to the oven for 30 seconds or more and then restore it.
Read the supporting manualSafety with C-20: Switch the oven off at its breaker before you disconnect or reconnect power, and let the cavity cool.
Read the supporting manualC-21 (oven temperature high) differs from C-20 by a single character, and Samsung lists it as a separate entry for this wall oven. C-23 (temp probe sensor) differs from C-20 by a single character, and Samsung lists it as a separate entry for this wall oven.
Read the supporting manualManufacturer document
Samsung Electronics America (official manual PDF, downloadcenter.samsung.com)
DG68-00856A-03, printed footer 2018-08-29; PDF modified 17.04.2019; carries Warranty (U.S.A) on the same page as the code table (p59) / PDF p58
Manufacturer document
Samsung Electronics America (official manual PDF, downloadcenter.samsung.com)
Samsung user manual PDF created 15.01.2026 (no printed revision code on the cover) / PDF p65
Scope: NV51**700D** built-in electric wall ovens (NV7000C series); NV51K7770D* built-in electric wall ovens. Source: Built-In Electric Wall Oven User manual NV51K7770D*; Built-In Electric Wall Oven User manual NV51**700D**, checked November 2026.
Both wall oven manuals (NV51K7770D* and NV51**700D**) say the oven sensor is open, or short, while the oven is operating.
No. The manuals print both readings under the one code with the same steps.
On a small display the 0 in C-20 can be taken for O or o. Samsung's wall oven list has no row spelled that way, so C-20 is the reading to look up.
The manuals say to call for service if the power reset does not solve it. Book a visit with us.
Samsung codes, symptoms, parts, house calls
C-d0 on a Samsung built-in wall oven means the control key is shorted for 1 minute. Wipe the buttons clean, dry any water on or around them, then switch the oven off and try again.
If food bakes or roasts poorly in a Samsung wall oven, the manual looks first at controls set incorrectly, a rack in the wrong place or not level, and wrong cookware. An oven that runs too hot or cold may need its thermistor adjusted in Settings, Adjust Temp. Low voltage can also slow broiling.
Book a diagnostic for your exact model, carried out beside the appliance.
Office details, and the access notes to send us.